Truck / Industrial Heads. Tapping for water

http://home.together.net/~twaters/

Moderator: TrWaters

Post Reply
TrWaters
Posts: 390
Joined: Fri Dec 14, 2001 6:00 pm
Location: Vermont
Contact:

Truck / Industrial Heads. Tapping for water

Post by TrWaters »

With prices going up, and car heads getting used, many are going to truck or industrial heads. One question always seems to come up. "Where do I drill for water?"
The answer has always been somewhat vague. On the ends. :wink:

Hopefully this will help. This is a cutaway of a Chrysler truck head. It is actually casting number 1733463, and typical of this type of head. It has always been thought that you would need to drill close to the extended casting in the corner to hit water.
As you can see, the entire end is open for water. Hope this helps.

Image

Another thing that may be of interest is the oil drainback hole. It can be enlarged, but not by much.
Early hemi to late sb Mopar trans adapters. Precision billet parts for early hemis.
Post Reply