Computer for stock alternator
Moderator: scottm
-
- Posts: 5
- Joined: Mon Sep 14, 2009 2:20 pm
Computer for stock alternator
I am putting a 6.1 hemi in my 47 Dodge pickup. I will be changing to carburetors and am using an MSD controller to run the engine. Is there a computer out there to utilize the stock alternator to charge the system? OR any ideas would be appreciated. Thanks!
-
- Posts: 488
- Joined: Sat Nov 30, 2002 2:16 pm
Re: Computer for stock alternator
You can use the stock Mopar two pin electronic voltage regulator. That's what I did on the 5.7 in my Cuda. Just wire the two small wires from the alternator to the voltage regulator and splice in a 12 volt wire to one of them from the ignition circuit and you're good to go!
Owner of the Poor Man's Hemi Cuda