5.7 in '65 dodge
Moderator: scottm
5.7 in '65 dodge
Anybody know anything about swapping new hemi's in old mopars? I am using the factory computer and wiring harness, but am not sure about running aftermarket guages that I have. It looks to me like the factory sending units for oil pressure and water tempereture go through the computer. I am afraid that if I run the new sending units for VDO guages, it will tell the computer there is no oil pressure. Any help is appreciated.
-
- Posts: 37
- Joined: Sat Dec 31, 2005 7:54 am
- Location: MARYLAND
- Contact:
YOUR PCM WILL USE ONE SET OF SENDING UNITS AND THE GUAGES WILL USE A SEPERATE SET.I WOULDN'T USE THE FACTORY PCM EITHER,I'D PROBABLY USE AN AEM ENGINE MANAGEMENT SYSTEM.I HAVE SOME INFO ON MY SITE http://mysite.verizon.net/ls6ron/