I'm performing an '04 5.7 swap and I'm running into some difficulties.
I did not get the pedal assembly with the wiring, and I either have figure out a way to make this assembly drive by wire, or I have to figure out the requirments and make this piece with a linear potentiometer in order to operate the throttle body. I haven't made a firm decision on which I will accomplish.
Does anyone have the schematics of the inside of the ETC assembly?
I have the service manual, but they don't go into the ETC.
Does anyone have an extra pedal assmebly?
Also, Does anyone know if I made a drive by wire system, would the computer have a problem as long as I still had the TPS portion hooked up?
This is just one of my many issues that I'm bound to have. Anyway some advice would be great. Thanks
5.7 Hemi Swap (Accelerator Pedal Position Sensor)
Moderator: scottm
5.7 Hemi Swap (Accelerator Pedal Position Sensor)
//Hot Rod '37//
Mike Tipton
Mike Tipton